Question 950
An administrator will use FortiGate HA role swap versus FortiManager device inventory to keep management stable when the firewall cluster elects a different active member. Before sign-off, which setup step must be completed for that approach?
Explanation
Correct Answer
The specific preparation for FortiGate HA role swap versus FortiManager device inventory is to verify the cluster's current primary member and management protocol mapping in FortiManager. This addresses the stated need to keep management stable when the firewall cluster elects a different active member, and later acceptance is demonstrated when central inventory reflects healthy cluster state after FortiGate role change.
Incorrect Answers
That step belongs to Manager failover changes registered endpoint, used to repair managed FortiGates that continue contacting a failed manager after manual HA takeover. It is not the mechanism-specific setup for FortiGate HA role swap versus FortiManager device inventory required to keep management stable when the firewall cluster elects a different active member.
That step belongs to FortiManager HA peer heartbeat loss, used to isolate a manager backup marked Down even while the primary GUI is healthy. It is not the mechanism-specific setup for FortiGate HA role swap versus FortiManager device inventory required to keep management stable when the firewall cluster elects a different active member.
That step belongs to FGFM keepalive failure to registered FortiGate, used to diagnose a device marked disconnected after previously successful secure registration. It is not the mechanism-specific setup for FortiGate HA role swap versus FortiManager device inventory required to keep management stable when the firewall cluster elects a different active member.



Fortinet NSE 5 - FortiManager 7.6 Administrator (FCP_FMG_AD-7.6) Practice Tests